Britax FRONTIER 85 SICT Bedienungsanleitung

IMPORTANT: Thoroughly read and follow all instructions before installing this child seat. Store this user guide in the pocket behind the cover (See fe

16 17Insert one tongue at a time into the buckle. NOTE: Proper connection is confirmed with an audible click after inserting each buckle tongue.Fasten

18 19Using the LATCH ConnectorsThe LATCH connectors are located on the sides of the shell in the storage slots. Store the LATCH connectors when not in

20 21WARNING!• Longbeltpathisonlyforusewithalap-shoulderbelt.NeverusethelongbeltpathoptionwithLATCHoralapbelt.• Useonly the

22 23LATCH – Short PathBefore you begin: 9 Check that your vehicle has LATCH anchors.* Check your vehicle owner’s manual for the vehicle’s LATCH anc

24 25Lap-Shoulder Belt – Selecting a Belt PathDue to variability in vehicle seat designs and belt systems, the Frontier 85 SICT child seat can be secu

26 271 Rotate the positioning block to the front and place the child seat on the vehicle seat.* Ensure harness height is adjusted to fit your child.

28 291 Rotate the positioning block to the front and place the child seat on the vehicle seat.* Ensure harness height is adjusted to fit your child.

30 311 Rotate the recline block to the front and place the child seat on the vehicle seat.* Ensure harness height is adjusted to fit your child.2 P

32 336 Turn and slide the retainer through the slot to remove.* Pull the harness webbing tight from the other side before pulling the retainer throu

34 3513 Pull the adjuster strap to tighten the harness. * Pull the harness adjuster away from the child seat (parallel to the ground) to tighten. Se

2©2011 Britax Child Safety, Inc. All rights reserved. Printed in USA P464800_R1:03.11This product and its components are subject to change without no

36 371 Detach the Versa-Tether® hook from the storage clip.2 Ensure the positioning block is rotated to the back. 3 Place the child seat on the

38 39WARNING!• Never route the vehicle belt over the child when using this child seat in harness mode. • Adjust the belts provided with this child s

40 41Booster ModeWARNING! • Only use a lap-shoulder belt to secure the child in booster mode.• Use the shoulder belt guides on the child seat to ens

42 43Care and Maintenance Care and Maintenance1 Loosen the harness. a Press release leverb Pull both harness straps forward2 Unbuckle the harness,

44 45Care and Maintenance Care and MaintenanceCleaning the Cover• HAND WASH the cover using cold water and mild soap.• LINE DRY to prevent the cover

46 4711 Reattach the clips behind the arm rests and slide the fabric under the lower belt guides. Buckle Removal1 Locate the metal retainer on the

48 49Energy-Absorbing TetherThe Versa-Tether can indicate when the child seat has been in a moderate or severe crash and replacement of the child seat

50 51This child seat was manufactured by Britax Child Safety, Inc. Britax® warrants this product to the original retail purchaser as follows:LIMITEDO

52Notes

Britax Child Safety, Inc.13501 South Ridge DriveCharlotte, NC 28273USAA Britax Childcare Group Limited companyTel. : 1-888-427-4829www.Britax.com

2 3Safety InformationSection Title• Harness mode: use only with children who weigh between 25 and 85 lbs (11.3 and 38.6 kg) and whose height is betwe

4 51 Cover2 Side Impact Cushion3 LATCH Strap4 Arm Rest5 Cup Holder6 Head Restraint7 Head Restraint Cover8 Harness Slot9 User Guide Storage

6 7Harness Mode:Children must:1 be at least two years of age and2 weigh between 25 – 85 lbs (11.3 – 38.6 kg) and3 stand 30 – 57 in. (76.2 – 144.8 c

8 9Compatible Vehicle Seat BeltsNOTE: The information in this section only applies to installation with vehicle belts. Vehicle seats and seat belts di

10 11AdjusterLatchPlateLap BeltIMPORTANT: A Lap belt may only be used to install the child seat in harness mode and should never be used to secure you

12 13WARNING! Some vehicles have no seating positions which are compatible with this child seat or any other child seat. If in doubt, contact th

14 15WARNING! Head restraint adjustment is for use in Booster Mode ONLY. DO NOT Use the head restraint adjuster when the harness is attached.1 Remov